Simpatie.ro - matrimoniale
Forum Romania Inedit
Romania Inedit - Resursa ta de Fun
Nou pe simpatie:
Profil Cenusareasa
Femeie
24 ani
Bucuresti
cauta Barbat
28 - 61 ani
Forum Romania IneditReguliInregistrareLoginPozeNu sunteti logat. Lista Forumurilor Pe Tematici
Forum Romania Inedit / Tech Support /

Problema DVD-RW

Pagini: 1 Moderat de maharet
#1
Amstel
MEMBRU VIP
Din: Comuna cu Blocuri
DMA-driver error, CRC error

Acu' o lună am postat aici nişte probleme cu DVD-RW, problema persistă, am căutat mai "adānc" pe net şi am avut plăcerea de a găsi poate problema principală pentru arderea CD-urilor şi a DVD-urilor


Primary IDE Channel





Secondary IDE Channel



Din cāte am citi eu pe site-ul respectiv, am īnţeles că DVD-RW este un "sclav" pentru DVD-ROM, adică el ar avea doar funcţia de DVD-ROM

Textul l-am găsit pe net, este īn engleză, īl puteţi citi AICI

Pe mine mar interesa, dacă cineva īmi poate spune cum să fac sa aleg, sau să-mi reiasă la CURENT TRANSFER MODE - ULTRA DMA MODE 3 [sau să fie aceaşi valoare]



Orice răspuns e folositor.

_______________________________________
=====================================
.....:::::  powerer by Amstel  :::::.....
=====================================

 
   
#2
Amstel
MEMBRU VIP
Din: Comuna cu Blocuri
Nu are nimeni o informaţie ?

_______________________________________
=====================================
.....:::::  powerer by Amstel  :::::.....
=====================================

 
   
#3
locust
Moderator
Folosiţi cablu IDE cu 80 de fire.



   
  *  Blue: The blue connector attaches to the host (motherboard or controller).
    * Gray: The gray connector is in the middle of the cable, and goes to any slave (device 1) drive if present on the channel.
    * Black: The black connector is at the opposite end from the host connector and goes to the master drive (device 0), or a single drive if only one is used.

# Hard Disk Support: The hard disk itself must support Ultra DMA. In addition, the appropriate Ultra DMA mode must be enabled on the drive.
# Controller Support: A controller capable of Ultra DMA transfers must be used. This can be either the interface controller built into the motherboard, or an add-in IDE/ATA interface card.
# Operating System Support: The BIOS and/or operating system must support Ultra DMA transfers, and the hard disk must be set to operate in Ultra DMA in the operating system.
#

80-Conductor Cable: For Ultra DMA modes over 2, an 80-conductor cable must be used. If an 80-conductor cable is not detected by the system, 66 MB/s or 100 MB/s operation will be disabled.


Respect!


_______________________________________
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

 
   
#4
Amstel
MEMBRU VIP
Din: Comuna cu Blocuri
Merci, am schimbat IDE pe albastru si MERGE... am reusit sa  scriu un DVD, sper sa meraga si la CD-uri, si sa nu mia faca probleme

Ai o bere 

CLOSE


_______________________________________
=====================================
.....:::::  powerer by Amstel  :::::.....
=====================================

 
   
#5
locust
Moderator




Respect!


_______________________________________
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

 
   

Topicuri similare

Pagini: 1  
Mergi la